The system of use of nitrogen basically works with the exhaust produced by combustion of fuel, which is put into operation through a switch. Once the car has been accelerated to 3,000 rpm, one has to push this button for 3 seconds and after that the tension of the car is stopped and thus moving to another coil that produces raw gas which leaves the exhaust pipe and these gases are ignited by the action of a spark plug.
What this system does is that it creates a fault for the raw gas to leave the exhaust and it is likely that the car will tend to fade. It is usually easier to use this while the vehicle is running because it will not be as prone to go off as it is when the car is stopped, and this effect could also hold fire longer.
For the realization of the system what is exactly needed is apart from a very good city some of the important elements required are a relay of 5 feet, a long foot and a spark tower attached to it, which are used to troubleshoot when a barrel of oil remains showing the spark plug and fillings, ignition coil as the coil fire hereafter is called to distinguish them clearly from the original reel that comes with the car, a switch with 2 contacts and 14 number wire.
Wiring Relay is used for the wiring of the relay 5 which connects the terminal legs 87 and 30 to a cable that comes from the original negative of the coil car and the two cables coming from the negative. The terminal 85 is connected to the positive of the battery. The terminal 86 is one of the terminals in the switch. The terminal 87 is connected to the negative of the new coil.
Installing the fire coil is done by placing the coil in a fire close to the exhaust pipe, usually in the trunk. The coil has two terminals, as explained above the negative of the coil is connected to relay 87, while the positive terminal is connected to the positive of the battery.
Installing the spark plug and its tower The tower should be placed in the exhaust so that the threaded plug in it is situated at least at half of the exhaust pipe.
Placing the switch, as the switch has 2 terminals as mentioned before one of them is connected to terminal 86 of the relay, while the other goes to the ground.
Tags: battery, exhaust, exhaust pipe, vehicle